Electrical and Structural properties of Copper Oxide (CuO) Thin Films on Plastic Substrate Deposited by Spray Pyrolysis Technique

Keywords: Copper oxide, Chemical Spray Pyrolysis, Polyimide, This Film

Abstract

 In this paper, copper oxide (CuO) thin films were deposited on polyimide plastic substrates by spray pyrolysis technique at different temperatures from 250 to 300°C. All the deposited films were characterized by X-ray diffraction (XRD) technique, ultraviolet (UV)-visible spectrophotometer, and hall effect measurements for the investigation of structural, optical, and electrical properties. The effects of substrate temperature on the structural, optical, and electrical properties of the films were studied. The XRD results revealed that all the CuO films have a facecentered cubic structure. The crystallite grain size was calculated using Scherrer formula and it was found that at the substrate temperature of 300°C, the CuO film presented maximum crystallite grain size of about 81.2 nm. The root mean square (RMS) roughness of the films was measured by scanning tunneling microscopy. RMS was increased with the rise of temperature. The optical transmission measurements by UV-visible spectrophotometer were used to determine the energy gap of the CuO films. Results showed that the optical energy gap has decreased with increasing the substrate temperature. Hall effect measurements showed that all the films are of p-type conductivity. Depending on the substrate temperature, hall measurement showed that the electrical resistivity and carrier concentration are varied from 77.4 Ω cm to 52.7 Ω cm and from 6.3 x1015 cm-3 to  10.1 x1015 cm-3., respectively.

Downloads

Download data is not yet available.

Author Biographies

Mohammad G. Faraj, Department of Physics, Faculty of Science and Health, Koya University, Koya KOY45, Kurdistan Region

Mohammad Ghaffar Faraj is an Assistant Professor at the Department of Physics, Koya University. He received his B.Sc. and M.Sc. degrees in physics, both from the University of Al-Mustansiryah, Iraq, in 2001 and 2004, respectively. He received his Ph.D. degree in solar energy from the School of Physics; University Sains Malaysia (USM), Malaysia, 2012. He completed Post-doctorate Fellow, Polymer Thin Film, in 2017 from University of Santiago de Compostela (USC), Spain. His research interests include solar cells, thin films, nanotechnology, polymers, and photodetectors Heterojunction.

Askander K. Kaka, Department of Physics, Faculty of Science and Health, Koya University, Koya KOY45, Kurdistan Region
Askander K. Kaka is a Lecturer at the Department of Physics, Faculty of Science and Health, Koya University. He got the B.Sc. degree in Al-Mustansiriya University, the M.Sc. degree in Al-Mustansiriya University and the Ph.D. degree at the University of Baghdad. His research interests are in Thin films, Nanostructures simulation and Antenna simulation. Dr. Askander is a member of Kurdistan Teachers Union.
Halo D. Omar, Department of Physics, Faculty of Science and Health, Koya University, Koya KOY45, Kurdistan Region
Halo D. Omar is a Lecturer at the Department of Physics, Faculty of Science and Health, Koya University. He got the M.Sc. degree in Material Physics from the University of Poitiers - France. His research interests are: Material Physics, Solar energy and Nanotechnology.

References

Abbas, S.Z., Aboud, A.A., Irfan, M., and Alam, S., 2013. Effect of substrate temperature on structure and optical properties of Co3O4 film prepared by spray pyrolysis technique. IOP Conference Series Materials Science and Engineering, 60, pp.012058.

Akkari, F.C., Kanzaria, M., and Rezig, B., 2007. Preparation and characterization of obliquely deposited copper oxide thin films. European Physical Journal- Applied Physics, 40, pp.49-54.

Amri, A., Duan, X.F., Yin, C.Y., Jiang, Z.T., Mahbubur, R.M., and Pryor, T., 2013. Solar absorptance of copper-cobalt oxide thin film coatings with nano-size, grain-like morphology: Optimization and synshrotron radiation XPS studies. Applied Surface Science, 275, pp.127-135.

Birks, L., 1946. Particle size determination from X-Ray Line Broadening. Journal of Applied Physics, 17, pp.687-692.

Chandrasekaran, S., 2013. A novel single step synthesis, high efficiency and cost effective photovoltaic applications of oxidized copper nano particles. Solar Energy Materials and Solar Cells, 109, pp.220-226.

Chaudhary, Y.S., Agrawal, A., Shrivastav, R., Satsangi, V.R., and Dass, S., 2004. A study on the photo electrochemical properties of copper oxide thin films. International Journal of Hydrogen Energy, 29, pp.131-134.

Dolai, S., Dey, R., Das, S., Hussain, S., Bhar, R., and Pal, A.K., 2017. Cupric oxide (CuO) thin films prepared by reactive d.c. magnetron sputtering technique for photovoltaic application. Journal of Alloys and Compounds, 724, pp.456-464.

Faraj, M.G., and Omar, H.D., 2014. The effect of substrate temperature on the structural properties of spray pyrolysed lead sulphide (PbS) thin films. Aro the Scientific Journal of Koya University, 2, pp.11-14.

Faraj, M.G., and Pakhuruddin, M.Z., 2015. Deposited lead sulfide thin films on different substrates with chemical spray pyrolysis technique. International Journal of Thin Films Science and Technology, 4, pp.215-217.

Faraj, M.G., and Taboada, P., 2017. Comparative studies of the properties of ZnO sprayed thin films on different polymer substrates for flexible solar cell applications. Journal of Inorganic and Organometallic Polymers and Materials, 27, pp.1405-1411.

Faraj, M.G., and Taboada, P., 2017. Structural and optical properties of ZnO thin films prepared by spray pyrolysis on PI plastic substrates at various temperatures for integration in solar cell. Journal of Materials Science: Materials in Electronics, 28, pp.16504-16508.

Faraj, M.G., Ibrahim, K., Eisa, M.H., and Alrajhi, M.A., 2014. Comparison of aluminium thin film deposited on different polymer substrates with thermal evaporation for solar cell applications. Journal of Ovonic Research, 10, pp.231-235.

Faraj, M.G., Pakhuruddin, M.Z., and Taboada, P., 2017. Effects of substrate temperature on structural and optical properties of spray pyrolyzed Cu(Ga0.3In0.7) Se2 thin films on polyimide plastic substrate. Journal of Electronic Materials, 46, pp.6745-6749.

Faraj, M.G., Pakhuruddin, M.Z., and Taboada, P., 2017. Structural and optical properties of cadmium sulfide thin films on flexible polymer substrates by chemical spray pyrolysis technique. Journal of Materials Science: Materials in Electronics, 28, pp.6628-6634.

Haug, F.J., Geller, Z.S., Zogg, H., Tiwari, A.N., and Vignali, C., 2001. Influence of deposition conditions on the thermal stability of ZnO: Al films grown by rf magnetron sputtering. Journal of Vacuum Science and Technology, A19, pp.171-174.

Hubner, M., Simion, C.E., Tomescu-Stanoiu, A., Pokhrel, S., Barsan, N., and Weimar, U., 2011. Influence of humidity on CO sensing with p-type CuO thick film gas sensors. Sensors and Actuators B, 153, pp.347-353.

Hussein, A.N., Muhammad, S.K., Mohsin, S.A., and Ajeel, F.N., 2015. Study on structure and optical properties of CuO thin films prepared by chemical spray pyrolysis. Journal of Applied Physical Science International, 4, pp.178-184.

Ismail, R.A., and Faraj, M.G., 2009. Study of optical and electrical properties of CdO prepared by chemical spray pyrolysis. Journal of College of Education, AL-Mustansiriyah University, 3, pp.532-539.

Lee, J.H., Park, B.O., 2004. Transparent conducting In2O3 thin films prepared by ultrasonic spray pyrolysis. Surface and Coatings Technology, 184, pp. 102-107.

Mariammal, R.N., Ramachandran, K., Kalaiselvan, G., Arumugam, S., Renganathan, B., and Sastikumar, D., 2013. Effect of magnetism on the ethanol sensitivity of undoped and Mn-doped CuO nanoflakes. Applied Surface Science, 270, pp.545-552.

Mohamed, J.R., Sanjeeviraja, C., and Amalraj, L., 2016. Influence of substrate temperature on physical properties of (111) oriented CdIn2S4 thin films by nebulized spray pyrolysis technique. Journal of Asian Ceramic Societies, 4, pp.191-200.

Morales, J., Sanchez, M., 2005. Use of low-temperature nanostructured CuO thin films deposited by spray-pyrolysis in lithium cells. Thin Solid Films, 474, pp.133-140.

Muhammad, F.F., and Sulaiman, K., 2011. Utilizing a simple and reliable method to investigate the optical functions of small molecular organic films Alq3 and Gaq3 as examples. Measurement, 44, pp.1468-1474.

Muhammad, F.F., Yahya, M.Y., Aziz, F., Rasheed, M.A., and Sulaiman, K., 2017. Tuning the extinction coefficient, refractive index, dielectric constant and optical conductivity of Gaq3 films for the application of OLED displays technology. Journal of Materials Science: Materials in Electronics, 28, pp.14777-14786.

Nalbant, A., Ertek, O., and Okur, I., 2013. Producing CuO and ZnO composite thin films using the spin coating method on microscope glasses. Materials Science and Engineering, 178, pp.368-374.

Oztas, M., Bedir, M., Kayalı, R., and Aksoy, F., 2006. Influence of the annealing conditions on the properties of InP thin films. Materials Science and Engineering: B, 131, pp.94-99.

Tauc, J., 1974. Amorphous and Liquid Semiconductors. Plenum Press, New York.

Valladares, L.D.L., Salinas, D.H., Bustamante, D.A., Acosta, N.D., Khondaker, S.I., Mitrelias, T., Barnes, C.H.W., Albino, J., and Y.M, 2012. Crystallization and electrical resistivity of Cu 2 O and CuO obtained by thermal oxidation Cu thin films on SiO2/Si substrates. Thin Solid Films, 520, pp.6368-6374.

Published
2019-12-10
How to Cite
Faraj, M. G., Kaka, A. K. and Omar, H. D. (2019) “Electrical and Structural properties of Copper Oxide (CuO) Thin Films on Plastic Substrate Deposited by Spray Pyrolysis Technique”, ARO-THE SCIENTIFIC JOURNAL OF KOYA UNIVERSITY, 7(2), pp. 14-18. doi: 10.14500/aro.10558.